Collector installation
6
SKS 4.0 Series - Flat roof and wall mounting - We reserve the right to make any changes due to technical modifications.
30
6.1.2 Fitting the end cap
Not all the connections are needed when connecting a
collector array, so those that are not used must be
closed.
z
Remove rubber caps (transport protection) from the
relevant collector connections.
z
Push end cap with the O-rings (Fig. 42,
Item 3
) onto
the collector connection.
z
Push bracket (Fig. 42,
Item 2
) over the end cap and
collector connection to secure the connection.
6.2
Fastening the collectors
The collectors are fastened to the profile rails using the
single-sided collector clamps (Fig. 43,
Item 2
) at the be-
ginning and end of a collector array, and double-sided
clamps (Fig. 43,
Item 1
) between each collector.
In addition, the anti-slip protectors (Fig. 43,
Item 3
) pre-
vent the collector from slipping.
Fitting the single-sided collector clamp on the right
z
Push single-sided collector clamps (Fig. 44,
Item 1
)
into the profile rails at the right-hand end of the coll-
ector array until they click into place in the first slotted
hole on the profile rails.
Fig. 42
Securing end cap with bracket
63043966.12-2.SD
63043966.12-2.SD
2
3
1
CAUTION!
SYSTEM DAMAGE
from unsecured end caps.
z
Secure each end cap with a bracket
(Fig. 42,
Item 1
).
Fig. 43
Fasteners for the collector
63043970.26-1.SD
63043970.26-1.SD
2
1
3
USER NOTE
The plastic parts on the collector clamps
do not have any support function. They are
simply intended to make installation ea-
sier.
Fig. 44
Pushing on the single-sided collector clamp
63043970.31-1.SD
63043970.31-1.SD
1
USER NOTE
Do not fit the single-sided collector clamps
to the left-hand side of the collector array
until the last collector has been installed.