Buchi Rotavapor R-200, Руководство по эксплуатации

Страница: 20 / 60

20
BÜCHI Rotavapor R-200/205
4.14 Combination with Büchi Vacuum Controller
V-800/805
The new Büchi Vacuum Controllers V-800/805 are optimally
adapted to the design of the Rotavapor R-200/205.
Scoe of delivery
If the Vacuum Controller V-800/805 and valve unit are ordered
together with the Rotavapor R-200/205, these are already
installed into the units.
Retrofitting
If a Rotavapor R-200 or R-205 is retrofitted, you must proceed
as follows:
Fixation
• Screw out screw
!
and pull the cover plate to the back.
This cover
%
will not be used any more.
• Remove the cable socket
"
and plug it into the Vacuum
Controller.
• Place the Vacuum Controller V-800/805 on the special
cover
#
and draw the cover from the rear side on the
Rotavapor. Fix the cover with the screw.
• Control cable
$
for the Rotavapor
The holding device for the valve unit can be fixed on the left
side of the tower of the Rotavapor. The valve unit can be fixed
on the holding device.
Cabeling of the Rotavapor
&
Connect mains supply bath to the mains
'
Connect mains supply of rotary evaporator to the mains
(
R socket on Vacuum Controller is connected to the socket
on the Rotavapor
)
Switchbox socket on the V-500 is connected to the
”PUMP” socket on the Vacuum Controller
*
Valve socket on Vacuum Controller is connected to the
valve unit
,
+
CW socket on Vacuum Controller is connected to the
cooling water valve
,
Valve Unit
Picture 19: Installation of Vacuum Controller on Rotavapor
4 Putting into operation
!
# "
$
*
+
)
'
(
&
,
%