btsr SMART 200 TSS, Руководство по эксплуатации, Страница: 45 / 93

Operation
SMART 200 TSS -3.29 -
D_CNTR - Configuration of Sensor delay time before entering the Control status
SETUP #
# #
#
CONFIG
#
# #
#
D_CNTR
This function allows you to delay the sensor entry into the yarn quality control
status (CONTROL).
This delay can be freely set (from 1 to 250 seconds) depending on the needs, for
instance to give the operator enough time to prepare the position and the machine
to reach the rated speed.
The delay time set here acts on all connected sensors. After any operation
involving a manual activation of the sensor, this will start the actual operation, i.e.
to signal possible defects only when such delay time has elapsed. (The delay time is
indicated by the green Led flashing).
Once you have selected the D_CNTR function from CONFIG menu, press to
have access to the function.
Set the desired value (1-250 seconds) using or
Press to confirm the entered value.
The D_CNTR WAIT message, shown for a few seconds indicates that the function
has been programmed correctly.
At the start-up, or after a failure reset, the green Led will flash for a time
corresponding to the set delay, then it will remain permanently lit..
Press once to return to the CONFIG menu, or twice to return to the Main
Menu.
A
8