VIDEO DOOR ENTRY MODE - Configurator SPE=9
CONFIGURATION
This mode of operation interacts with the video door entry system assigning some functions to the radio control such as: switching
on the staircase lights, call to the floor and opening the door lock from the entrance panel.
Mode (M1, M2) configuration:
The mode configurators
M1
(pair of keys 1-3) and
M2
(pair of keys 2-4) must be configured in one of the following ways:
–
M=1
:
double command for door lock opening
A
and
PL1
(if M1=1 and M2
≠
0) are the address of the entrance panel which will control the door lock: key 3 controls the
entrance panel door lock (A/PL1) while key 1 controls the entrance panel door lock (A/PL1)+1.
A
and
PL2
(if M2=1) are the address of the entrance panel which will control the door lock: key 4 controls the entrance panel
door lock (A/PL2) while key 1 controls the entrance panel door lock (A/PL2)+1.
The address of the entrance panel specified in A/PL1 or in A/PL2 must be 95 or less than 95.
–
M=2
:
command for call to the floor
A
and
PL1
(if M1=2) and/or
A
and
PL2
(if M2=2) are the address (two digits) of the handset to call.
–
M=3
:
command to switch on staircase lights
A
and
PL1
(if M1=3) and/or
A
and
PL2
(if M2=3) are the address (two digits) corresponding to the handset which will control
the staircase lights.
In general if PL2 and M2 are not configured, the right keys (2 and 4) are disabled.
The only exception to this is:
–
M1=1
,
M2=0
,
PL2=0
:
quadruple command for door lock opening
A
and
PL1
are the address (two digits) of the entrance panel which will control the door lock: key 3 controls the door lock
of entrance panel (A/PL1), key 4 controls the door lock entrance panel (A/PL1)+1, key 1 controls that of entrance panel
(A/PL1)+2 and key 2 that of entrance panel (A/PL1)+3. The address of the entrance panel specified in A/PL1 must be 95 or
less than 95.
19
To associate a radio device to interface L/N/NT4575SB,
proceed as follows:
1) Press the pin pushbutton on the interface for at least 3 seconds: the red LED shines steadily. Release the key.
2) Within 20 seconds press a key on the radio control of the pair which you want to program; the red LED flashes quickly indicating
that the programming has taken place.
3) At this point points 1 and 2 can be repeated for all the codes to be saved inside the interface,
up to a maximum of 128
.
Interface L/N/NT4575SB configuration
Radio control L4572SB
Entrance panel 22
A
1
PL1
3
M1
1
PL2
0
M2
0
SPE
9
Example of configuration:
Interface L/N/NT4575SB configuration
Entrance panel 21
Staircase lights 26
Staircase lights 26
Entrance panel 15
Entrance panel 13
Entrance panel 16
Entrance panel 14
1
2
3
4
1
2
3
4
Radio control L4572SB
A
2
PL1
1
M1
1
PL2
6
M2
3
SPE
9
PROGRAMMING
