To cancel a scenario
, proceed as follows:
1) The scenario module must be in configuration with self-learning enabled.
2) Press the pin pushbutton on the interface for at least 8 seconds (after 3 seconds the red LED shines steadily, after another 5
seconds it goes out). Release the key. The red LED lights up again.
3) Within 20 seconds press the key on the remote control for the scenario to be cancelled; when the scenario module sends
confirmation that the cancelling has taken place the red LED flashes quickly for about 2 seconds and then goes out.
4) Repeat points 2 and 3 for all the scenarios to be cancelled.
To cancel all the interface programmings simultaneously,
press the pin pushbutton on the interface for about 12 seconds (after
3 seconds the red LED shines steadily, after another 5 seconds it goes out and after another 4 seconds it flashes quickly for about
2 seconds, confirming the cancellation). Release the key.
Note:
with this operation the scenarios in the scenario module are not cancelled.
Cancelling all the scenarios
: to do this press the self-learning key so that the self-learning LED becomes green then press the DEL
key directly on the scenario module for 10 seconds.
18
SOUND SYSTEM MODE - Configurator SPE=8
CONFIGURATION
This mode of operation implements the sound system functions.
In this mode of operation, the radio control keys work as indicated below:
Room (A) and Sound Point (PL1) configuration:
–
A=0-9:
is the amplifier room;
PL1=0-9:
is the amplifier sound point;
–
A=AMB
: for
room
commands;
PL1=0-9:
is the room for which the command is intended;
–
A=GEN
: for
general
commands;
PL1
must be
0
.
Mode (M1) configuration:
–
M1=0-9:
source to be switched on before switching the amplifier on; if
M=0
source 1 is switched on without switching the
sources OFF first (in Follow-me mode).
Configurators PL2 and M2 must be 0.
To associate a radio control item L4572SB with interface L/N/NT4575SB,
proceed as follows:
1) Press the pin pushbutton on the interface for at least 3 seconds: the red LED shines steadily. Release the key.
2) Within 20 seconds press the key on the radio control which you want to program; the red LED flashes quickly indicating that the
programming has taken place.
3) At this point points 1 and 2 can be repeated for all the codes to be saved inside the interface,
up to a maximum of 128
.
To cancel a code from interface L/N/NT4575SB,
proceed as follows:
1) Press the pin pushbutton on the interface for at least 8 seconds (after 3 seconds the red LED shines steadily, after another 5
seconds it goes out). Release the key. The red LED lights up again.
2) Within 20 seconds press one of the four keys which you want to cancel; the red LED flashes quickly for about 2 seconds to
indicate that the cancelling has taken place.
3) From this moment the command is cancelled until it has been reprogrammed.
To cancel all the codes of interface L/N/NT4575SB
, press the pin pushbutton for about 12 seconds (after 3 seconds the red LED
shines steadily, after another 5 seconds it goes out and after another 4 seconds it flashes quickly for about 2 seconds, confirming
that all the programmings have been cancelled). Release the key.
1
2
3
4
Key 1
Press quickly to activate the source
and the amplifier.
Press for longer to increase the volume.
Key 3
Press quickly to switch the amplifier OFF.
Press for longer to decrease the volume.
Key 2
Change sound source.
Key 4
Change tune or radio station.
PROGRAMMING
