Page | 18
3.
Connect to the AutoSync WiFi network. Once your phone is connected, the AutoSync
configuration menu should appear automatically on your phone. If it does not appear within a
few seconds, open your phones web browser and go to the website “10.10.0.1”
4.
The AutoSync will then list all of the WiFi networks that are within range. If your WiFi network
does not appear, wait a few seconds. If your WiFi network still does not appear within ~10
seconds, check that your WiFi router is working, and the AutoSync is within range of your router.
NOTE: The AutoSync can only connect to 2.4ghz WiFi networks. 5ghz WiFi is not supported.
5.
Click on your home WiFi network name and type in your WiFi router password
(note: passwords
are case-sensitive).
The AutoSync will now attempt to connect to your WiFi network. If the
connection is successful, your phone will exit the AutoSync configuration menu, and the radio
screen will show “WiFi connection Success. AutoSync will now connect to the internet to check
for new firmware”. If the AutoSync does not connect within 10 seconds, double check that your
WiFi password is correct, unplug the AutoSync, plug it back in and try again. NOTE: You only
have to do this WiFi setup procedure once. The AutoSync will permanently save your WiFi info.
6.
Once the AutoSync has connected successfully, within a few seconds, the radio screen will show
“Downloading new firmware! DO NOT DISTURB AUTOSYNC”. The AutoSync is now downloading
the updated firmware from the internet and reprogramming itself. When the firmware
download has completed (it should take less than 30 seconds), the radio screen will show
“Firmware Update Success”. Press the radio home button to reboot and load the new firmware.
If the radio screen shows “Update Failed! Error: xxxxxxx”, exit the AutoSync menu, turn the
ignition OFF, unplug the AutoSync for 10 seconds, plug it back in, and try the update procedure
again. If it still fails after multiple attempts, this is most likely due to a bad internet/WiFi
connection.
7.
If update procedure seems to be hanging for more than several minutes, (stuck on “Firmware
download – do not disturb” message), turn the ignition OFF, unplug the AutoSync for 10
seconds, and try update procedure again. If the firmware update screen is “stuck” on the radio
and you cant clear it…unplug the AutoSync, plug it back in, and press the cruise “CANCEL”
button to re-initialize the AutoSync menu.