BSVILLAGE BWT SHOTT SP 3600, Руководство по установке

Страница: 23 / 56

23
EN
MANUALE_SP3600_BWT-A5 - Rev: 01/2020
PROBLEM POSSIBLE CAUSE 1° SOLUTION 2° SOLUTION
5. The product
does not work.
The
thermal pro-
tector
has been
triggered.
Check that the water
temperature does
not 35 [°C]
and, if necessary,
add cold water to the
pool
to lower water
temperature.
Contact specialised
technicians.
The
thermal pro-
tector
has been
triggered.
Blocked drive shaft,
follow the instruc-
tions in Blocked
rotor .
The bearing are
worn out.
Replace the bearing
6. Water leak.
Gaskets or o-rings
incorrectly installed
Check correct gasket
and o-ring installa-
tion, see Fig. 19, # 1,
2, 3, 4, 5.
Contact specialised
technicians.
7. Loss of water from
mechanical seal
.
A
mechanical seal
is
used to isolate the
pump body and the
motor body. Some
drops of water may
flow out once in a
while this is normal,
especially after peri-
ods of non use
If the leaks are consistent Please contact
specialised technicians..
8. Blocked
rotor
.
Foreign bodies
block the rotating
elements of the
product (
impeller
or
cooling fan).
Remove any foreign
bodies.
Contact specialised
technicians.
Blocked drive shaft,
it can happen after
a long period of
inactivity.
Do the following:
1. unplug the prod-
uct from the power
outlet ;
2. make the drive
shaft turn 9-10 times,
using a screwdriver
as shown in Fig. 18;
3. insert the power
plug
of the product
into the
power outlet
.
9. Retail and spare parts and relevant documentation.
See Tab. 3 with reference to Fig. 19.
Replace any damaged and/or worn components as quickly as possible; use only original spare parts.
TAB. 7