Description
1
12
ekr 500 web guiding controller
EDV No.: MD.299.01.06
Chapter: 1
with removable control panel
Date:
29.07.08
Page:
7/86
1.5.2 Sensor 1 / Sensor 2
In this operating manual, the sensors that are connected to the
controller are designated with “
sensor 1
“ and “
sensor 2
“.
According to the BST definition, the following link applies between
the selection buttons for the guiding mode and the sensors:
= Sensor 1
(left web edge)
= Sensor 2
(right web edge)
The following is valid in respect of the sensor mounting positions:
The sensor, which is located to the left of the material in the
web running direction (when looking from the material top
side), is sensor 1.
The material top side is the side of the material web which is not in
direct contact with the deflection pulleys of the guiding device.
Example 1: Example
2: Example
3:
As standard,
sensor 1
must be connected to terminal strip
X1
,
while
sensor 2
must be connected to terminal strip
X2
of the
controller (
see terminal assignments, chapter 5.5
).
Sensor 1
Sensor 2
Sensor 1
Sensor 2
Sensor 1
Sensor 2
Pivot
Deflection pulley
Guiding device
