- 17 -
NOTE:
Drive belt must be placed around perimeter of media
before
re-installing! Make sure the seal
does not
roll off of the divider during media installation.
Figure B
Changing Media Seals:
1. Follow procedure for removing media.
2.
Inspect to determine method utilized to attach seal to flange, if no fasteners visible proceed to
next step, otherwise remove all fasteners before proceeding.
3.
Firmly grasp the bed seal and pull straight away from divider panel.
4.
Repeat above steps for opposite side.
NOTE:
Both perimeter and divider seals will be removed as one piece.
Installing Media Seals:
1.
Replacement seals shipped from the factory and require field fitting (cutting to length).
2.
Slip perimeter seal over flange taking care not to stretch seal during installation. Mark end and
cut the seal ¼’’ longer than required to ensure proper fit of mating surfaces (join under
compression when seal installed).
3.
Cut a small notch in the perimeter seal as required to allow for proper installation at the points
that the seal intersects the reactivation quadrant partitions.
4.
Install perimeter seal using a small amount of silicone rubber seal to bond the joint where the
two ends come together (note: do not bond seal to flange with silicone sealant).
5.
Slip divider seal into place on reactivation quadrant partition flange taking care not to stretch
seal. Mark and cut seal ¼’’ longer than required.
6.
Install seal using silicone rubber sealant at the points where the seal mates with the perimeter
