Brush Bandit 1290XP, Инструкция по эксплуатации и каталог запасных частей

Страница: 64 / 140

Bandit
Copyright 12/07 PAGE 6
MODELS 1290XP/1590 MAINTENANCE SECTION
EASY CLIMB FEED SYSTEM
Before attempting any type of maintenance disengage
clutch, turn off engine, wait for the disc/drum to come
to a complete stop, install the disc/drum lock pin,
disconnect battery, and make sure the ignition key is
in your possession.
The Easy Climb System allows you to adjust the
amount of spring tension put on the top feedwheel.
The more spring tension you have the harder it will be
for your top feedwheel to raise. More spring tension
will keep the top feedwheel down on smaller brush
material. The less spring tension you have the easier
it will be for the top feedwheel to raise. Less spring
tension allows the top feedwheel to raise, and climb
over the larger diameter material. Additional spring
tension requires more hydraulic yoke lift cylinder power
to raise the top feedwheel. May require slight hydraulic
relief valve adjustment.
There are four adjustment positions on the Easy
Climb System. When adjusting spring tension have
the top feedwheel in the lowered position. Use the
Clevis Pin with Clip to adjust the tension. Make sure
that the Clevis Pin is installed properly and that the
Clip is secured tightly in place.
With the pin in position 1 the Easy Climb System
will have approximately 6” (152 mm) of travel before
you start spring tension. Use this position when
chipping the maximum diameter material allowed by
the chipper.
With the pin in position 2 the Easy Climb System
will have approximately 4” (102 mm) of travel before
you start spring tension. Use this position while
chipping slightly smaller material than the maximum
diameter material allowed by the chipper.
With the pin in position the Easy Climb System
will have approximately 2” (51 mm) of travel before you
start spring tension. Use this position when chipping
brush type material.
With the pin in position the Easy Climb System
will have approximately 0” of travel before you start
spring tension. Use this position when chipping small
brush type material.
ADJUST ACCORDINGLY AS SPRINGS STRETCH.
POSITION
POSITION
CLEVIS PIN WITH
CLIP IN POSITION 1
SPRING
BOTTOM
MOUNT
B O T T O M
YOKE
POSITION 2
TOP YOKE
TOP
MOUNT
DANGER