If a foreign object is detected incorrectly, although the GPM surface is free, then a reset of the GPM is necessary,
i.e. the GPM must be disconnected from the power supply until the LED goes out. After switching the GPM on
again, a renewed initialization of the FOD is possibly necessary, see 7.3.1.2 Status: Initialization Foreign-/Living
7.3.1.8 Status: Cooling Fan Blocked
The GPM is reliant on a sufficient circulation of air, in particular during the charging process. If the fan duct is
clogged, and the fan is blocked, then you recognize this on the LED with this pattern. In this case please check the
cooling duct and clean it as required.
off
on
0,25s
0,25s
0,25s
0,25s
0,25s
0,25s
0,25s
4s
Figure 10: Flashing pattern in status Fan Blocked
7.4
GPM Cooling System Fan
Noise can be caused by the cooling function of the fan. The device is protected from overheating by an internal
function. Please treat the fan with care and observe the instructions for cleaning, see section 8.1 Cleanliness. In
particular clean the fan intake duct regularly. Do not use any high-pressure cleaner, such as e.g. Kärcher!
7.5
Emergency Situations
With the occurrence of emergency situations, follow the corresponding situation descriptions in the table below and
comply with the associated instructions!
SITUATION
INSTRUCTIONS
Development of smoke or fire in
the charging environment
1.
Keep calm!
2.
Remove yourself and if necessary other persons immediately from the source
of the fire and from the surroundings! Do not use the vehicle in the charging
station for this!
3.
Fetch help. Call the fire department!
4.
Keep other people away from the source of the fire!
5.
Visit a doctor in order to exclude smoke poisoning!
Feeling of numbness in the
extremities
1.
Keep calm!
2.
Remove yourself immediately from the charging environment!
3.
Visit a doctor.
Feeling unwell
1.
Keep calm!
2.
Remove yourself immediately from the environment of the charging station!
3.
Visit a doctor.
Operation Manual
Inductive Charging System
ICS115
34
