BRP I-Command Evinrude Etec Series, Руководство пользователя

Страница: 67 / 113

65
Use the UP or DOWN buttons to make selection. Review the following to
determine which choice will work best in your application.
FLUID LEV SNSR (Fluid Level Sensor) -
4. Fluid level sensor requires installation of a fuel tank level converter which
uses the fuel tank sending unit to calculate remaining fuel. Calculation is
based on sending unit accuracy, capacity entered during setup, and fuel
consumed from tank. Use the FIVE POINT calibration (see “Fuel and
Fluid Level Sensor Calibration” on page 61) to achieve the best accuracy.
ENG/FFLOW (Engine Fuel Flow) -
5. Engine fuel flow requires installation of memory module kit. Uses Out-
board’s EMM software to calculate fuel consumption. Total fuel use is cal-
culated based on EMM fuel tables and subtracted from fuel tank capacity
entered during setup.
A GPS antenna and memory module kit must be installed to track seasonal
fuel, trip fuel, fuel range, and economy.
IMPORTANT: Fuel flow data from the EMM is required. User must enter
amount of fuel added at each fill up (see “Refill Tank” on page 67) or perform
the “Partial Fill” procedure (see “Partial Fill” on page 67). A GPS antenna
must be installed for fuel management features to be functional.
M E N U
DOWN
UP
EXIT
PAGES
ENTER
Eng/Fflow
Fluid Lev Snsr
M E N U
DOWN
UP
EXIT
PAGES
ENTER
Eng/Fflow
Fluid Lev Snsr
5
4