88
Evinrude E-TEC
Engine Warnings
The
I-Command
gauges monitor engine conditions and display warnings in the event of a malfunction. The
following table lists warnings that are specific to
Evinrude E-TEC
models. Refer to the outboard Operator’s
Guide if any engine warnings are displayed.
WARNING MESSAGE DISPLAYED
POSSIBLE CAUSE / PROCEDURE
Sensor malfunction see dealer
Throttle position sensor fault detected
Analog 5V supply overload detected
Exhaust pressure circuit fault detected
RPM reductn activated see dealer
System Voltage below expected range
System Voltage above expected range
Winterization Mode activated
Auto-winterization routine activated
Overheat RPM reductn activated see manual
EMM temperature above expected range
Low battery voltage see manual
Battery voltage below expected range
Overheat Eng Shutdwn see manual
Engine shutdown, EMM above max temperature
Engine shutdown, engine above max temperature
No Oil Shutdwn see manual
Engine shutdown, excessive no oil fault
No Oil RPM reductn check oil
Oil solenoid open circuit
Water in Fuel, service soon
Water in fuel detected
Содержание I-Command Evinrude Etec Series
