BRP Can-Am RYKER 2019 Series, Руководство оператора, Страница: 36 / 179

BASIC PROCEDURES
Starting and Stopping the
Engine
Starting the Engine
IMPORTANT: At start-up, engine RPM
will slightly increase by itself before
running its normal rotation.
WARNING
Exhaust gas contains poisonous
carbon monoxide that can rapidly
accumulate in an enclosed or
poorly ventilated area. If inhaled,
it can cause serious injury or
death.
Only run the engine in an unen-
closed, well ventilated area. See
AVOID CARBON MONOXIDE POI-
SONING
.
1. Open the right side service cover
and read the Safety Card as needed
to prepare yourself, your passenger
and the vehicle, before starting the
vehicle.
2. Install the RF D.E.S.S. key on the
D.E.S.S. post.
219001998-042
3. Briefly, press the start button to
wake-up the electrical system.
4. Set the engine stop switch to the
RUN position.
1
2
219001998-012
1. RUN position
2. STOP position
5. Twist gently the throttle handle
away from you (raise your wrist) to
activate the starting system.
– Once this motion is done, release
the throttle handle.
– The engine can be started in the
next 30 seconds without doing
this motion again.
– Each time the engine is stopped,
this motion must be performed
to start the engine.
219001998-041
6. Push down and hold the brake
pedal.
7. Press the start button, no need to
hold it to start the engine.
NOTE: If the engine does not start,
press the start button again.
8. Check the display for problems and
to ensure that the oil light turns off.
9. Release the park position lever.
Make sure the indicator on the mul-
tifunction gauge cluster is off.
34
______________