Attach two Legs (Ref. No. 1) to each Side
Panel (Ref. Nos. 4 & 5). Place leg over holes
so that edge of panel will be to the inside. At
the top hole of each Leg, use 10-24 x 3/4”
Bolt, 3/16” Washer, 10-24 Nut (Ref. No. 18, 20
& 21), two per leg. These bolts are required
if stacking units. Use 10-24 x 1/2” Bolt, 3/16”
Washer, and 10-24 Nut (Ref. Nos. 19, 20 & 21)
at all other locations.
For easier assembly, turn unit upside down
so that all panels will rest on even edges.
Start the body assembly with the Feeder Side
Panel (Ref. No. 4) and the Front Panel (Ref.
No. 2). This will insure that all units will be
identical, and that the drinker is always in the
front of brooder. Use same fastener locations
previously indicated. Hand tighten fasteners
only.
Install all remaining panels. Hand tighten
fasteners only.
Stand Unit upright on four (4) legs. Unit may
be slightly unstable and may not stay square.
STEP 3
Attach Floor Bracing (Ref. No. 10) across
assembly from one Drop Pan Channel (Ref.
No. 6) to the other, using 10-24 x 3/8” Bolt and
10-24 Nut, (Ref. Nos. 22 & 23).
NOTE: Nut (Ref. No. 23) must be placed on
the inside of Drop Pan Channel (otherwise you
will have trouble sliding floor screen in and
out).
STEP 4
#22 - OF3 (6x)
#10 - CQB205 (3x)
#23 - OF53 (6x)
2
1
A
B
A
B
1
2
#20 - OF118 (30x)
#18 - OF44 (8x)
#20 - OF118 (30x)
#19 - OF214 (22x)
#1 - CQB201 (4x)
#21- OF415 (30x)
#5 - CQB211
#2 - CQB208
#4 - CQB210
2
1
A
B
A
B
1
2
#7 - CQB204 (6x)
#5 - CQB211
#2 - CQB208
#3 - CQB209
#19 - OF214 (24x)
#20 - OF118 (24x)
#21 - OF415 (24x)
2
1
A
B
A
B
1
2