Attach Window Channels (Ref. No. 7) to Front
Panel, Back Panel, and Side Panel, (Ref.
Nos. 2, 3 & 5), using 10-24 x 1/2” Bolt, 3/16”
Washer, and 10-24 Nut, (Ref. Nos. 19, 20 &
21). Window channel should fit flat against
panels with form openings facing each other.
Tighten all window channels.
NOTE: When using all fasteners with washer,
always place washer with bolt, insert bolt and
washer through the part and then place on the
nut.
STEP 1
Attach Drop Pan Channels (Ref. No. 6) to
the inside of both Side Panels, (Ref. Nos. 4
& 5) using Fasteners (Ref. Nos. 20, 21 & 22).
Make sure the three 1/4” holes on each drop
pan channel are facing toward top.
NOTE: The Locknut (Ref. No. 21) must be
placed on the outside of the Unit, so that the
Drop Pan (Ref. No. 13) may slide in and out
after assembly. Tighten locknuts.
STEP 2
ASSEMBLY INSTRUCTIONS
DO NOT TIGHTEN ANY FASTENERS UNTIL INSTRUCTED TO DO SO!
CQB20 Brooder has a heater for brooding. CGO20 Grow-Out Pen is identical to CQB20 except that
it has no heater.
Optional CQB600 Caster Base is designed for either CQB20 or CGO20.
WARNING
Be sure Power Cord Assembly is not connected during installation or cleaning. Remove heater before cleaning.
Do not touch either lug of the thermostat if power source is connected. Touch only the adjustment knob. Do not
defeat electrical ground afforded by 3-prong Cord Assembly. Model AT10 Adjustable Thermostat and Model
BRHTR20 should be repaired only by a qualified electrician. Failure to follow these and other safety precautions
could result in electrical shock causing serious injury or death!
!
!
#7 - CQB204 (6x)
#5 - CQB211
#2 - CQB208
#3 - CQB209
#19 - OF214 (24x)
#20 - OF118 (24x)
#21 - OF415 (24x)
2
1
A
B
A
B
1
2
#4 - CQB210
#6 - CQB203 (2x)
#19 - OF214 (10x)
#20 - OF118 (10x)
#21 - OF415 (10x)
#5 - CQB211
2
1
A
B
A
B
1
2