Brother PS-9000, Руководство пользователя

Страница: 45 / 47

44
PS-9000 Settings
Below are the settings for PS-9000.
General
TCP/IP
Name
Factory
Default
Explanation
CD-ROM
Setup
Web page
LAN Interface AUTO
Set up network type. Normally use in
AUTO. If the LINK LED on the hub
does not light up after the PS-9000 is
turned on, select the appropriate
network type for the hub.
Name
Factory
Default
Explanation
CD-ROM
Setup
Web page
Receive IP
address
automatically
DHCP/BOOTP ENABLE
Enables or disables DHCP/BOOTP.
These are protocols where the IP
address is acquired from the
DHCP/BOOTP server during start up.
In order for DHCP/BOOTP to specify
the IP address of PS-9000, a
DHCP/BOOTP server must exist
within the subnetwork and be
properly set up. PS-9000 will
automatically acknowledge DHCP
and BOOTP, and use as its own
address the IP address that it
previously received as a reply.
RARP ENABLE
Enables or disables RARP. RARP is a
protocol where the IP address is
acquired from the RARP server during
start up. In order for DHCP/BOOTP to
specify the IP address of PS-9000, an
RARP server must exist within the
subnetwork and be properly set up.
IP Address IP Address 0.0.0.0
Sets up the IP address of PS-9000. The
value must be configured in the
format of four series of numbers
separated by decimal points, such as
“xxx.xxx.xxx.xxx”.