Brother P-touch PRO DX PT-9200DX, Руководство по обслуживанию

Страница: 47 / 104

II - 34
[4] Reassembly of the Cutter Assy, the Half Spacer, the Half Cutter
Assy, and the Eject Unit Assy
(1) Apply the specified grease (3 mm
3
) on each slot of the cams in the cutter
assy and the eject unit assy, where the cutter rock pin slides up and down.
(Specified grease: Silicone grease G501)
(2) After inserting the cutter rock pin into the groove in the movable blade of
the cutter assy, insert the two locating shafts of the frame assy into the
round and oblong holes.
Warning : Take care not to be injured by the blades of the cutter assy
and the half cutter assy otherwise danger will be caused.
(3) Insert the two locating shafts of the frame assy into the round and oblong
holes in the half spacer.
(4) After inserting the half rock pin of the half cutter assy into the groove in the
half rock gear, insert the two locating shafts of the frame assy into the
round and oblong holes.
(5) After setting the eject cam of the eject unit assy on the cutter rock pin,
insert the two locating shafts of the frame assy into the round and oblong
holes.
(6) While pressing the vicinity of the screws to be tightened on each of the
above four units, tighten the two screws.
Fig. 2.2-43 Reassembly of the Cutter Assy, the Half Spacer,
the Half Cutter Assy, and the Eject Unit Assy
Cutter assy(Full cutter assy)
Locating shafts
Half spacer
Half cutter assy
Eject unit assy
Two screws
Apply the grease here.
Cutter rock pin
Apply the grease here.
Cutter rock pin
Mechanical unit