CHAPTER 9 BANYAN VINES NETWORK CONFIGURATION
9-5
C. Print Server Configuration Using BRAdmin
The last step is to add the StreetTalk login name to the Brother print server
and to associate the file server queue with one of the services on the print
server. The procedure is as follows:
1. Install the software from the Print Server Configuration Utility
diskette by selecting File from the Windows Program Manager menu
bar. Then select Run, enter
A:\SETUP.EXE
as the command line,
click OK, and follow the instructions on the screen.
2. Start the BRAdmin program.
3. The Brother print server node name (BRO_xxxxxx_P1 or
BRO_xxxxxx, where "xxxxxx" is the last six digits of the Ethernet
address) will show up in the list. If it does not, double-check your
Ethernet cabling and (if applicable) hub connection. Click on this
name with the mouse button. You will be asked for a password, the
default password is “access”.
4. Click on the Configure button.
5. Click on the Banyan tab.
6. The Banyan hop count is set by default to two hops, which is adequate
for most networks. However, if the file server is located more than
two hops from the print server, you must set the hop count to the
appropriate value.
7. Enter the StreetTalk name of the print server (this must exactly match
the name you entered in Step A-3). If the SteetTalk name has spaces
in it, you must enclose the name in double quotation marks (for
example, "john smith@uc_engineering@irvine"). If you entered a
password in step A-3, you should also enter the same password here.
8. Click on the Services tab.
9. Double click on the service you wish to enable for VINES. If in
doubt, use BINARY_P1 (for the BIO port). Refer to Appendix B of
the manual for additional information on using services.
10. Type in the StreetTalk name of the print queue you defined in step B-3.
11. Click on OK, and then click OK again to save the configuration.
12. Click OK and then OK again to exit BRAdmin.
