Brother MFC-9420CN, Руководство по обслуживанию

Страница: 311 / 428

Confidential
9-55
(5) Make the following selection. Make sure that your print server appears. If it is visible, then
the connection is good. Otherwise, go to Step 5.
5. If you have tried 1 to 4 above and it does not work, then reset the print server back to the
default factory settings and try from the initial setup again. For information how to reset to
the default factory settings.
6. Check if a personal firewall such as ICF (Internet connecting firewall) for Windows XP is
running on your computer. If it is running, temporarily turn it off and try again.
NOTE: If none of the above steps are successful, there is almost certainly a hardware or network
problem.
� Printing problem
<Print job is not printed>
Make sure the status and configuration of the print server. Check following:
1. Make sure that the machine is powered on, is on-line and ready to print.
2. Print the Printer Settings Page of the machine and check if the settings such as IP address
settings are correct for your network. The problem may be the result of mismatched or duplicate
IP address. Verify that the IP address is correctly loaded into the print server. And make sure
that no other nodes on the network have this IP address.
3. Verify that the print server is on your network as follows:
For Windows
®
(1) Try pinging the print server from the host operating system command prompt with the
command:
ping ipaddress
Where ipaddress is the print server IP address (note that in some instances it can
take up to two minutes for the print server to load its IP address after setting the IP
address).
(2) If a successful response is received, then proceed to Windows
®
95/98/Me and Windows NT
®
4.0 Peer-to-Peer print (LPR) troubleshooting, and Windows
®
2000/XP IPP troubleshooting.
Otherwise, proceed to Step 4.