Brother FAX-270MC, Руководство по обслуживанию

Страница: 62 / 220

IV – 12
(8) For the FAX-270MC/290MC/520DT/520MC/MFC370MC/390MC: Take out the
microphone* and its harness* from the control panel.
Bosses
Main-mike harness*
Control panel
Latches
R
(9) To take out the LCD, remove the control panel PCB and the FPC key in step (6). As
shown below, insert the tip of a flat screwdriver under clamp “D” in the direction of arrow
F and push up clamp “D” slightly to release the LCD from clamp “C.” In the same way,
insert the screwdriver under clamp “A” to release the LCD from clamp “B.”
Then push out the LCD with your fingers in the direction of arrow R.
Flat screwdriver
(Rear)
■
Reassembling Notes
• To put the LCD back into place, insert the tip of a flat screwdriver under clamp “D” (see
the above illustration) in the direction of arrow R, push up clamp “D” slightly, and then put
the right edge of the LCD under clamp “D.” In the same way, insert the screwdriver under
clamp “A” to put the left edge of the LCD under clamp “A.”
Then push the LCD into place with your fingers in the direction of arrow F.
• When installing the LCD, take care not to scratch or damage the cover sheet. Replace it
if scratched or damaged.
• A new LCD is covered with a protection sheet. Before installing it, remove the protection
sheet.
F
R
F
"C"
"D"
"A"
"B"
LCD
* Provided on the FAX-270MC/290MC/520DT/520MC/
MFC370MC/390MC.