13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
50
BE-438C
<Memory switches 10 - 1F>
Switch
Motion when set to ON
memo-10
The optional emergency stop switch can be used.
memo-11
On when a two-stage tensioner is used. (Special order device that outputs from option output No. 1)
(Normally the tension opens when output is OFF, and the tension closes when option output No. 1 is
ON)
memo-12
Pneumatic wiper can be used. (Special order device that outputs from option output No. 2)
memo-13
−
memo-14
Solenoid wiper can be used (available as an option).
memo-15
−
memo-16
Needle cooler can be used (available by special order).
memo-17
Thread take-up device is not operated at the sewing end.
memo-18
Thread take-up device operates one stitch before the sewing end.
memo-19
Presser position errors are not detected.
memo-1A
Needle up stop position errors are not detected.
memo-1b
Presser can be moved up and down before the home position is detected.
(Normally the presser cannot be moved up and down until after the home position has been
detected.)
memo-1c
−
memo-1d
−
memo-1E
Errors can be reset using the EMERGENCY STOP switch.
(EMERGENCY STOP switch is available as an option.)
memo-1F
Thread is not trimmed when an emergency stop occurs during sewing.
(EMERGENCY STOP switch is available as an option.)
<Memory switches 20 - 2F>
Switch
Motion when set to ON
memo-20
−
memo-21
Rotating-type thread breakage detector operates. (Device is available by special order.)
memo-22
During thread breakage detection, sensitivity is decreased from 8 to 14 stitches at the sewing start.
(Sensitivity during sewing is three stitches.)
memo-23
When DIP switch A-8 is simultaneously ON, setting values changed using the operation panel are
ignored.
memo-24
−
memo-25
−
memo-26
Enables the fiber-type thread breakage detector (when memo-21 is ON)
memo-27
−
memo-28
Stores the amount of parallel movement in memory.
(Use the memory all clear operation to clear the setting.)
memo-29
−
memo-2F
−
