5. OPERATION
19
BE-438C
5-2. Operating procedure
Preparation
Turn on the power switch.
* The POWER indicator (1) will illuminate and the
program number will flash in the display window (14).
* For checking the origin points for X and Y feed
Note when creating additional data
When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle operation), the
upper shaft motor may overheat and the “E-20” error code may be generated.
5-2-1. Setting the program number
Determine the appropriate program from the program list which is given on pp. 3 - 5.
1
Press the SELECT switch (6)
until the PROGRAM NO. in-
dicator illuminates.
2
Press the DISPLAY SET
switches (12) until the desired
program number is flashing in
the display window.
3
Depress the foot switch to the
second step.
* The display will stop flashing and
illuminates steadily, and the feed
mechanism will move to the
sewing start position.
This completes the setting of the program
number.
5-2-2. Setting the X-scale and Y-scale
1
Press the SELECT switch (6)
until the X-scale or Y-scale
indicator illuminates.
2
Press the DISPLAY SET
switches (12) until the desired
scale setting is flashing in the
display window.
(The setting is displayed as a per-
centage.)
3
Depress the foot switch to the
second step.
* The display will stop flashing and
illuminates steadily, and the feed
mechanism will move to the
sewing start position.
This completes the setting of the X-scale or
Y-scale.
Note:
Be sure to check the sewing pattern (refer to page 21) after setting has been completed to make sure that the needle
drops down into the hole of the botton.
Factory default
Variable range
Program No.
0
*
1 - 49
X-scale (%)
100
20 - 200
Y-scale (%)
100
20 - 200
Speed (rpm)
2,000
1,000 - 2,500
1st step
2nd step
0085Q
2516Q
2517Q
2518Q
2519Q
0085Q
1st step
2nd step
