6. STANDARD ADJUSTMENT (MECHANISMS)
6-1-2. Adjusting slider base F
1. Loosen the two bolts
q
, move slider base F
w
so
that it is aligned with fork bracket F
e
, and then
tighten the bolts
q
.
NOTE:
●
Check that loosen loop presser plate B
r
and
loosen loop presser plate F
t
do not touch
loop presser UB
y
or loop presser UF
u
when
the air has been released and the fork bracket
is moved to about the middle of loop presser
F
i
and loop presser B
o
.
●
If the upper guide plate
!0
gets in the way,
remove the two bolts
!1
and then remove the
upper guide plate
!0
.
●
Refer to "6-1-5 Adjusting the upper guide
plates" on page 50 for details on the upper
guide plate.
2. Loosen the two bolts
!1
, move the loop hold plate
!2
in between loop presser F
i
and loop presser B
o
, and then tighten the bolt
!1
.
1. Release the air, loosen the bolt
q
, and then move
the cylinder stopper
w
up by the amount of drop.
After adjusting, tighten the bolt
q
.
NOTE: Raise the slider bracket as high as possible
while ensuring that the belt loops do not go
under the loop pressers B
e
F
r
.
6-1-3. Adjusting the height of the slider bracket
―
50
―
BAS-705
e
r
q
w
q
w
!2
r
e
t
!1
y
u
!0
!1
i
o
!2
