Programmer
129
Chaprter 3 Programming with Command Function
3.
Input the stitch length and press
M
.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4.
Move the work clamp with
. Press
L
when the needle point is at point B of the
pattern.
5.
Move the work clamp with
. Press
L
7
8
9
when the needle point is at point
C of the pattern.
Point C becomes a sharp corner. The range from points A to C
is programmed.
6.
Press
M
.
To change the stitch length, specify the pitch value before
pressing
M
.
7.
Move the work clamp with
. Press
L
when the needle point is at point D of the
pattern.
8.
Repeat step 7 and create the program to
point E.
9.
Press
L
7
8
9
as in step 5.
The range from points C to E is programmed.
10. Create the program to point I in the similar
manner.
2
Inputting the end code
1.
Press
E
1
1
1
.
The work clamp returns to the start position.
3
Saving
1.
Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
Содержание BAS-311E
