Brookstone 324464, Инструкция по безопасности и эксплуатации

Страница: 10 / 19

ONE-BUTTON TAKE OFF AND LANDING
As an alternative to the take off and landing procedure described on Page 14, you can use
the one-button method .
1 . Press the Take Off/Landing/Emergency Stop Button . The drone will fly up and keep
flying at an altitude of approximately 47 inches (1 .2 meters) .
Press the Take Off/Landing/Emergency Stop Button again and the drone will land . DO
NOT HOLD THE BUTTON and do not touch the left stick, or the function will fail .
EMERGENCY LANDING
If the drone is in an emergency situation, such as if it is about to hit people or obstacles,
press the Take Off/Landing/Emergency Stop Button and hold it for more than 1 second . The
propellers will stop immediately and the drone will land quickly .
Note: Do not use the Emergency Stop function unless it is an emergency . The drone will fall
suddenly after all propellers stop .
16
ALTITUDE HOLD MODE
Altitude Hold mode allows the drone to maintain a consistent altitude while allowing roll, pitch,
and yaw to be controlled normally . This mode makes it easier for beginners to control the
drone and makes the drone more stable for aerial photography .
To use Altitude Hold Mode, push the left stick up to fly the drone up, or press the stick down
to fly down, to your desired altitude, and then release the stick . The stick will move back to the
center position (Altitude Hold Center), as shown below .
The drone will continue flying at its current altitude . Repeat to change the drone altitude .
SPEED MODE SWITCH
Use the Speed Mode switch to select the appropriate speed . Low speed is suitable for
beginners, medium speed is suitable for skillful pilots to play in a gentle breeze, and high
speed is suitable for expert and experienced aerial stunt flyers . The default is medium speed .
Set your speed before beginning your flight .
Speed Mode Switch
17