To enter the system diagnostic mode use a small screwdriver to press and release the MODE button on the back of
the unit. All segments will flash green almost immediately.
Quickly release the MODE button, the system diagnostic mode is now activated.
On entering the system diagnostic mode the TEST segment will flash green
inviting you to press the button.
When you press the button the TEST segment will turn blue and all the
Alarms in the system will sound for 2 minutes.
This will allow you to walk around the house and verify that each individual
Alarm is sounding. During the test you may notice the TEST segment flash
blue periodically indicating that a refresh signal is being transmitted.
The test will automatically cease after 2 minutes or if the button is pressed
again. All the segments will flash green to indicate the test has been
completed. Wait 2 minutes before performing any additional tests.
Two minute - Long test
Fire / CO Alarm Controller
Fire / CO Alarm Controller
Fire / CO Alarm Controller
21
