RadioLINK enabled Smoke and CO Alarms have the ability to record if they have been
previously activated and store it in their memory. This can then be recalled via the
diagnostic mode.
On entering the system diagnostics mode, if an alarm memory has been set, the MEMORY
segment will flash green and the Fire or CO indicator will flash. Press the button until
the MEMORY segment turns blue. This will then locate the Alarm that was previously
activated and cause it to sound for a number of seconds (depending on the number of
RadioLINK Alarms and devices in the system).
Pressing the button again will cause it to sound again. This allows you to walk around
the house until you have found the activated Alarm.
The Alarm Controller will automatically exit the alarm identification test after 2 minutes
or if the MODE button is pressed again. All segments will turn green for a brief period as
the Alarm Controller exists the system diagnostic mode.
22
Check Alarm memory
Fire / CO Alarm Controller
Fire / CO Alarm Controller
Fire / CO Alarm Controller
