Brooks CryoPod, Быстрый старт

Страница: 3 / 32

English
I
3
Alarm 2 (Critical)
Program
Temperature Program Alarm 2 to
desired critical set point,
which will trigger when
the chamber warms
up and reaches this
temperature. Adjust tem-
perature by
1°C increments
using DOWN/UP
buttons.
Default: -140°C DOWN (C)
UP (D) Triple beep
sequence
every 10
seconds.
Pressing the
UP button
can silence
alarm. Add LN2 immedi-
ately, or transfer
samples to avoid
compromise if no
LN2 available. Alarm
will automatically
reset when unit
temperature is at
least 5°C colder than
critical set point.
Alarm 2 (Critical)
Set On/Off The alarm can be
enabled or disabled. Toggle between
Off and On
using DOWN/UP
buttons.
Default: On DOWN (C)
UP (D) Alarms will
sound for
20 minutes
before stop-
ping. Note LCD display
will have red back-
light, and blinking
“Alarm” indicator if
triggered.
System Alarms
Set On/Off All alarms can be
simultaneously enabled
or disabled. Toggle between
Off and On
using DOWN/UP
buttons.
Default: On (Bell
on LCD) DOWN (C)
UP (D) N/A Note LCD display
will have red back-
light, and blinking
“Alarm” indicator if
triggered.
Standby
Program
Temperature Power saving mode.
LCD will remain lit and
temperature visible,
while the chamber
continues to warm up
until it reaches -20°C, at
which point the unit will
power off. Adjust
temperature by
1°C increments
using Down/Up
buttons.
Default: -120°C DOWN (C)
UP (D) N/A
ID
Assign system ID 3 digit alphanumeric
system ID. Assign
each CryoPod a unique
system ID code to track
units and downloadable
temperature log data. Adjust each digit
by using DOWN/
UP buttons. Tog-
gle between each
digit by using the
SET button. SET (B)
DOWN (C)
UP (D) N/A
Low Mem
Set On/Off CryoPod
™
Carrier can
store up to 100 hours of
log data. Low memory
indicates there is less
than 6 hours of record-
able space remaining.
Existing log data must
be downloaded to free
up space.
Toggle between
Off and On
using DOWN/UP
buttons.
Default: On DOWN (C)
UP (D) N/A Temperature
log data can be
downloaded onto a
PC via the included
USB cable and
external CryoPod
™
Data Log software.
Time
The current time can
be programmed. This
setting is critical if you
will be utilizing the
temperature log data. Adjust each digit
by using DOWN/
UP buttons. Tog-
gle between each
digit by using the
SET button.
Format: HH:MM
AM/PM SET (B)
DOWN (C)
UP (D) N/A N/A
Date The current date can
be programmed. This
setting is critical if you
will be utilizing the
temperature log data. Adjust each
digit by using
DOWN/UP
buttons. Toggle
between each
digit by using
the SET button.
Format:
MM:DD:YY SET (B)
DOWN (C)
UP (D) N/A N/A
Once all parameters are programmed, hold SET button (B) down for 3 seconds to save
parameter settings.