Brooks Automation
2. Overview
Part Number: 257437 Rev. A
LCD System Display
In Set Mode – Operator has already entered into SET Mode
Short Press
Toggle through each
setting
Change Value
Up
Change Value
Down
Long Press
Off
Save Changes (Beep
confirmation)
NOTE:
If no button is actively pressed for 10 seconds when in SET Mode, the system
will exit the SET Mode without saving any changes.
LCD Indicators and Symbols
Indicator/
Symbol
Description
Alarm
"ALARM" text and alarm number with red back light will display if the
alarm is triggered.
Battery Symbol
A battery symbol consisting of an outline of a battery and three internal
sections indicating the charge remaining:
l
All three sections filled: >75%
l
Two sections filled: >50%
l
One sections filled: >25%
l
Battery outline <13%
Bell
The bell shaped symbol indicates that the unit will beep if an alarm is
triggered; if it does not appear on the LCD, then the sound was turned
off for both alarms.
CaL
CaL text in the ID Code field indicates TDISPLAY issue which must be
addressed by Brooks Automation technical support.
Crossed Bell
Crossed bell symbol indicates that the alarm was silenced by the
operator.
Firmware ID
An Alpha-numeric code indicating Firware ID in the date/time field that
will be displayed temporary when the system is turned on.
ID Code
The ID Code is shown as three alpha numeric digits on the upper right
hand corner of the LCD screen.
Log
LOG text appears on the LCD screen to indicate that a log event was
turned on.
Low Memory
LOW MEM is displayed when the available memory is not sufficient for
six hours of log data.
No Alarm
NO ALARM indicates that none of the alarms have been enabled.
OP
OP text on the LCD screen indicates an open sensor issue which must
be addressed by Brooks Automation technical support.
Copyright © 2016, Brooks Automation, Inc.
16
