26
Seat Cleaning and Removal
Use a soft, damp cloth and mild cleanser
(such as dish soap, Simple Green or Windex)
to wipe down the seat. DO NOT scrub or use
harsh, abrasive products to clean the seat. DO
NOT use thinner, benzene, acidic chemicals,
chloride, or hydrochloric acid detergent. This
may result in corrosion to the metal parts or
discoloration or scratches to the bidet body.
For a more thorough cleaning, you may
remove the bidet seat. To remove the seat,
press the Quick Release button on the right
side of the seat, and slide the seat forward off
of the mounting plate and toilet.
MAINTENANCE
Seat Cleaning, Removal, & Nozzle Cleaning
NOTE: Be cautious of leaving home
and beauty products in contact with the
bidet seat, as irreversible discoloration
can result. Most stains can be removed
using a 1:1 mix of rubbing alcohol and
water and a soft cloth or towel. However,
some permanent stains are the result
of substances left on the seat while the
seat heater was activated. Be cautious
of home and beauty products (including,
but not limited to: various hair and air
freshener sprays, lotions, body wash,
skin tanners, body butters, and oils) that
come into contact with the seat. Wash off
any substances that come into contact
with the seat as soon as possible. If
necessary, replacement seat parts can
be purchased through Brondell customer
support.
Nozzle Cleaning
There are two ways to initiate nozzle cleaning:
1. Regular cleaning
a. Press the Nozzle Cleaning button on the
control panel.
b. Nozzle will extend into the toilet bowl
and self-clean 3 times with cold water.
c. Nozzle will retract when finished.
d. Pressing the Stop button at any time will
cancel the nozzle cleaning process.
2. Intensive cleaning
a. Press the Nozzle Cleaning button for 3
seconds.
b. Nozzle will extend into the toilet bowl
and will self-clean 10 times with hot
water.
c. Nozzle will stop cleaning and will stay
extended for 5 minutes to allow for
manual cleaning.
d. Gently clean the
nozzle manually
with a soft cloth or
toothbrush.
e. After 5 minutes,
nozzle will perform
a self-cleaning rinse
10 times before
retracting.
f. Pressing the Stop button at any time will
cancel the nozzle cleaning process.
g. Pressing the Nozzle Cleaning button
during a self-clean will interrupt the
process; resume self-cleaning by pressing
the Nozzle Cleaning button again.
Step 2d
NOTE: The nozzle cleaning function will
not work if the seat is occupied, or if the
seat sensor has been overridden.
CAUTION
Unplug the Swash from the power source before cleaning or removing the seat.