brondell 1018505, Руководство пользователя

Страница: 28 / 92

26
TROUBLESHOOTING (cont.)
Problem Possible Cause(s) Solution(s)
Nozzles do not
function properly 1. Nozzles are dirty
2. Clogged filter
3. Water pressure is too low
4. External bidet filter
1. Clean nozzles (see maintenance
section)
2. Remove, clean, and reinstall mesh filter
(see maintenance section)
3. Check water supply valve at wall to
fully open
4. If you have an external bidet filter,
check and replace if necessary
Seat is not heated 1. Seat temperature set to off
2. Resettable fuse blown
1. Make sure that the Seat temperature set-
ting is on (Low- Blue light, Med- Pink light,
High- Red light, Off- No light)
2. The bimetal resettable fuse may blow if
the temperature exceeds over the normal
level. The bidet will not work and show an
error message until the bidet cools down.
The fuse will automatically reset
Bidet wash feature
does not work or
fails to spray 1. Body sensor does not detect that you
are sitting on the Swash 1a. Adjust sitting position to fully cover
the Body Sensor (see page 9).
1b. Override the body sensor – refer to
Special Mode Operation section on page
21 to unlock the body seat sensor.
Water (wash spray)
not heated 1. Water temperature set to off
2. Resettable fuse blown
1. Make sure that the Water temperature
setting is on (Low- Blue light, Med- Pink
light, High- Red light, Off- No light)
2. The bimetal resettable fuse may blow if
the temperature exceeds over the normal
level. The bidet will not work and show
an error message until the bidet cools
down. The fuse will automatically reset.
Water flows before or
after use 1. Water coming from nozzles 1a. The water that comes out between
the nozzles before or after a wash
cycle is the self-clean cycle and is not a
malfunction
1b. Residual water may drip into the
bowl for several seconds after a wash
cycle, self-clean cycle, or nozzle
sterilization cycle and is not a
malfunction.