Broncolor Move 1200 L RFS 2, Руководство по эксплуатации

Страница: 21 / 28

23
Acoustic fault indicator
If the flash fails to fire, a warning signal sounds for ca. 0.5 s and the display (4) for the appropriate
lamp blinks.
Acoustic signals
Beep sound:
End of charging or discharging
Double beep:
Energy demand above or below energy control setting via RFS 2 transmitter
"test" key held pressed for 4 s (reset to works settings)
Message in display Description
Thermo 1 Charging circuit overheated
(cooling phase = 15 min)
Thermo 2 Capacitors overheated
(cooling phase = 60 min)
Thermo 3 Resistors overheated
(cooling phase = 3 min)
Thermo 4 Battery overheated
(cooling phase = 15 min)
Thermo 5 Battery overheated
(cooling phase = 20 min)
Accu low 20 % Appears on reaching 20 % energy
remaining in battery
Charge defect Unit must be sent to Service
for repair
Overvoltage Unit must be sent to Service
for repair
Defect lamp 1 / lamp 2 Lamp 1 or lamp 2 is defective
or not correctly connected
Use broncolor tubes Please use only original broncolor
flash tubes
13. INFORMATION AND FAULT SIGNALS
Display Options Description
daily counter Number of flashes since the last reset
(reset with the "menu / enter" key)
flash counter Number of flashes since the power pack
was shipped
energy unit J
Ws Choice of unit for energy on the info display
serial number Displays the serial number. Only for Service
country Displays the country code. Only for Service
Power timeout 16 – 120 min Automatically switches the power pack
off after so many minutes without use.
prog.version Displays the program version. Only for Service