Broncolor Minipuls C200, Руководство по эксплуатации

Страница: 4 / 11

3
Safety information
Attention: Read before start up
- Prior to replacing the fuse, light bulb or flash tube, discharge the unit and
disconnect from power. Allow the unit to cool off for 10 minutes before replacing
the bulb or flash tube.
- Only those types of fuses indicated on the fuse label may be used. This is
particularly important for fusing the halogen lamp which may burst if the wrong
fuse is used.
- Only sand-filled fuses may be used. Sand-filled fuses can be identified by the
opaque body of the fuse.
-
The devices are designed for use in dry rooms. Protect them against splash
water and against excessive exposure to dust.
- The devices are not suitable for use in an explosions-hazard environment.
- The accessories mounted to the unit may heat up to high temperatures under
specific conditions. Handle with care !
- To protect against the effects of radiated heat, the unit must not be pointed at
flammable surfaces from less than 1 meter away.
-
Do not block the cooling louvers on the unit.
- Flash light contains, similar to sunlight, a specific portion of UV light. The
undesirable side effects on skin and eyes are considerably reduced by using
flash tubes with UV coating. Without these or other protective filters, use extreme
care when shooting.
- Even when disconnected from power, dangerous voltages may remain within the
interior of the device. For this reason, devices should only be opened by our
broncolor repair service .
-
For safety reasons, never operate a unit without the protecting glass in place.