Broncolor Minipuls C200, Руководство по эксплуатации

Страница: 9 / 11

8
The unit contains a temperature sensor which protects the electronic
circuitry from overload during long flash sequences. If the safety system is
activated, the modelling light goes out and charging is blocked. The ready
indicator light changes to red until the unit has cooled off. The fan will
continue to operate to promote faster cooling.
9. Afterglow block
The unit is equipped with an automatic afterglow block. If the flash tube
begins to exhibit afterglow (at the end of its service life, for example), this
block stops further charging to prevent any additional damage. The ready
indicator light also glows continuously red to indicate this condition. To
cancel the block, switch the unit off and then on again.
10. Mounting
The stand adapter is located below the housing. The adapter will accept
standard broncolor
®
bolts and Manfrotto
®
pins.
Make sure the lamp is firmly attached to the stand before operating. The
click-stops of the locking handle can be adjusted by pulling it out.
The enclosed locking pin has to be screwed into the lower part of the
stand adapter so it can be hung from a broncolor
®
bolt; this is not required
for stand mounting. A safety cable must be installed whenever the
lamphead is suspended.
11. Umbrella bracket
The umbrella reflector (art. no. 33.496.00) is used in conjunction with
umbrella diffusers and reflectors. The umbrella handle is inserted into the
special holder in the stand adapter.
12. Flash release
The release is possible via sync cable, infrared, photocell or with manual
trigger button.
The units are fitted with a synchronous circuit with low working voltage to
protect the camera contact. This synchronous contact may not be
switched parallel with outside brands since the latter work with high
synchronous voltage.