GSF3016E
Instruction Manual
Guide d’utilisation
8
Step 2 (Casters Assembly)
a) Screw one caster (W) into each pre-drilled hole on the foot of cart
side panel until secure.
b) Go back and tighten all bolts using the wrench provided.
Step 3 (Cart Back Panel Assembly)
a)
Loosen the lower pre-installed bolt on the leg of left
cart side panel and leave 1/4 of the bolt's length
extending from the leg. Align the hole on the cart
back panel (P) with the extended two bolts on the leg.
Push down on the cart back panel until it locks into
place. Align the middle hole on the leg of left cart side
panel with the hole on the cart back panel (P), then
insert one bolt (AA) with one lock washer (CC) and
one flat washer (DD) into each pre-drilled hole.
Tighten by hand until secure.
b)
Repeat the procedure for the assembly of cart back
panel and right cart side panel.
c)
Go back and tighten all bolts using the screwdriver
provided.
Step 4 (Install the bracket and tank support)
a) Insert the end of bracket (T) into the hole on cart
bottom panel as shown. Align the hole on the other
end of bracket (T) with the hole on the cart back
panel (P), then insert one bolt (AA) with one lock
washer (CC) and one flat washer (DD) into the
pre-drilled hole. Tighten by hand until secure.
b) Align the two holes on the tank support (S) with the
two holes on the right cart side panel, then insert one
bolt (AA), one lock washer (CC) and one flat washer
(DD) into each pre-drilled hole. Tighten by hand until
secure.
c) Tighten all bolts using the screwdriver provided.
