Open Defects in Fabric OS v7.0.1
Fabric OS v7.0.2 Release Notes v1.0
Page 65 of 99
Defect ID:
DEFECT000369286
Technical Severity:
Medium
Summary:
Inconsistency in handling of unsupported port speed configuration after replacing an FC16-
xx blade with an FC8-xxE blade.
Symptom:
After replacing an FC16-xx blade with an FC8-xxE blade, ports previously configured to fixed
10G speed will be reset to auto speed negotiation while ports previously configured to fixed
16G will be persistently disabled.
Workaround:
Manually correct the configured port speed and reenable the port.
Feature:
16G ASIC Driver
Function:
General
Probability:
High
Found in Release:
FOS7.0.1
Defect ID:
DEFECT000371302
Technical Severity:
Medium
Summary:
CEE/FCoE: protocol spanning tree config is not visible after spanning tree shut/no shut
Symptom:
If the customer changes the path cost to custom and does a shut/no shut the configuration
will have flat set as standard but rest of the config will remain as custom.
Workaround:
Reconfigure “port-channel path-cost custom” and then configure “port-channel path-cost
standard".
Feature:
CEE-LAYER2
Function:
STP
Probability:
Medium
Found in Release:
FOS7.0.1
Defect ID:
DEFECT000373589
Technical Severity:
Medium
Summary:
The error message for a duplicate user assigned FAPWWN will show the slot/port as -1/-1 if
the port is in a different logical switch.
Symptom:
If the user attempts to assign a WWN that has already been assigned to a port in a
different logical switch, the following message is displayed:
"Error: Virtual Port WWN is already mapped (FID <xxx>, Switch port -1/-1)."
This does not indicate the actual physical port with the duplicate WWN assignment.
Workaround:
Login to the FID indicated in the error message and issue "fapwwn --show all" to identify
which port has the WWN already assigned.
Feature:
Fabric Provisioning
Function:
CLI
Probability:
High
Found in Release:
FOS7.0.1
Defect ID:
DEFECT000374924
Technical Severity:
Medium
Summary:
Port Admin Dialog: FC8-32E and FC8-48E blades will list speed combo values which are not
supported on these platforms.
Symptom:
User will see speed combo values for FC8-32E and FC8-48E blades, but these settings are
not valid for these blade types.
Feature:
WebMgmt
Function:
Ports Admin
Probability:
High
Found in Release:
FOS7.0.1
