178
Brocade MLXe Series Hardware Installation Guide
53-1003030-01
Managing interface modules
5
Brocade(config)# lp boot system flash primary all
Syntax: lp boot system flash [primary | secondary] [all |
slot-number
]
•
The primary and secondary keywords specify the primary or secondary image in the interface
module flash memory.
•
The all |
slot-number
parameter specifies that the automatic boot applies to all interface
modules in the device or to an interface module in the specified slot number only. You can
specify 1 – 4 for 4-slot devices, 1 – 8 for 8-slot devices, 1 – 16 for 16-slot devices, or 1 – 32 for
32-slot devices.
Configuring an automatic boot from a TFTP server
To configure an automatic boot for all interface modules from a TFTP server, enter the following
command at the global CONFIG level of the CLI.
Brocade(config)# lp boot system tftp 123.123.123.123 primary all
Syntax: lp boot system tftp
ip-address filename
[all |
slot-number
]
•
The
ip-address
parameter specifies the IP address of the TFTP server from which the interface
modules will be booted.
•
The
filename
parameter specifies the name of the image from which to boot the interface
modules.
•
The all |
slot-number
parameter specifies that the automatic boot applies to all interface
modules in the router or to an interface module in the specified router slot number. You can
specify 1 – 4 for 4-slot routers, 1 – 8 for 8-slot routers, 1 – 16 for 16-slot routers, or 1 – 32 for
32-slot routers.
Configuring an automatic interactive boot
To configure an automatic interactive boot for all interface modules, enter the following command
at the global CONFIG level of the CLI.
Brocade(config)# lp boot system interactive all
Syntax: lp boot system interactive [all |
slot-number
]
The all |
slot-number
parameter specifies that the automatic boot applies to all interface modules
in the router, or to an interface module in the specified slot number. You can specify 1 – 4 for 4-slot
routers, 1 – 8 for 8-slot routers, 1 – 16 for 16-slot routers, or 1 – 32 for 32-slot routers.
After you enter this command, the system enters monitor mode on the interface module. To boot
from the primary image in flash memory on the interface module, enter the following command at
the monitor prompt.
LP MONITOR> boot system flash primary
Syntax: boot system flash primary
Changing priority of slots for interface modules
You can prioritize the slots in which the interface modules are installed. The priority range is 1 (low)
– 8 (high). You can set one, some, or all slots to the same priority or each slot to a different priority.
If you assign the same priority to all slots, the lowest-number slot has the highest priority, while the
highest-numbered slot has the lowest priority.
By default, the priority of all slots is 1, which is the lowest priority. If the supply of power to the
router falls below a minimum threshold, the slots will likely lose power because of their low priority.
In this scenario for an 8-slot router, slot 8 will lose power first, then slot 7, slot 6, and so on until slot
1 loses power.
Содержание BR-MLX-100GX-1
Страница 50: ...38 Brocade MLXe Series Hardware Installation Guide 53 1003030 01 Supported software features 1...
Страница 154: ...142 Brocade MLXe Series Hardware Installation Guide 53 1003030 01 RJ45 procedures 3...
Страница 164: ...152 Brocade MLXe Series Hardware Installation Guide 53 1003030 01 Testing network connectivity 4...
