Broaster 2004E, Руководство по обслуживанию

Страница: 42 / 92

4-8
RELAY (2400E)
If R1 Relay is faulty, the relay circuit pre-
vents the unit from being turned on after it
has been turned off. In this condition, the
filter motor will operate normally.
If the unit is off and the POWER ON light is
illuminated, replace R1 Relay.
There are two styles of relays that have
been used on the 2400E pressure Fryer. If
yours looks like the picture below then con-
tinue with step one, if not then go to step 7.
1. See ACCESS FOR SERVICE.
2. With needle nose pliers, disconnect
wire from terminal 4.
3. Check between terminal 4 and termi-
nal 5 with an ohmmeter. Meter should
indicate an closed circuit. If not, relay
is faulty.
4. Check between terminal 4 and termi-
nal 2 with an ohmmeter. Meter should
indicate a open circuit. If not, relay is
faulty.
1 3
6 5
2 4
5. With needle nose pliers, disconnect
one wire from the coil terminals (Termi-
nal 1 or 3).
6. Check between coil connections with
an ohmmeter. Meter should indicate a
closed circuit. If not, coil is faulty.
Relay Effective: S/N SE4A700011
7. With needle nose pliers, disconnect
wire from terminal 1.
8. Check between Terminal 5 and Termi-
nal 3 with an ohmmeter. Meter should
indicate an closed circuit. If not, relay
is faulty.
9. Check between terminal 5 and termi-
nal 1 with an ohmmeter. Meter should
indicate a open circuit. If not, relay is
faulty.
10. With needle nose pliers, disconnect
one wire from the coil terminals.
11. Check between coil connections with
an ohmmeter. Meter should indicate a
closed circuit. If not, coil is faulty.
broaster.com Manual #15460 8/02 Rev 6/15
1 2
4 3
6 5