Broaster 2004E, Руководство по обслуживанию

Страница: 40 / 92

4-6
HEATING ELEMENTS (2400E)
All elements heat the oil when the solid
state controller calls for heat. If HEAT ON
light is illumminated for long periods of
time, this may indicate a faulty element or
wire connection.
1. See ACCESS FOR SERVICE.
2. Disconnect all suspected element
wires from contactor.
3. Check for closed circuit from:
1-2
3-4
5-6
Heating Element Replacement:
1. See ACCESS FOR SERVICE.
2. Drain cooking oil from the cooking
well.
3. Remove side panel using a 7/16”
wrench or socket, remove the bolt
from both the front and rear of the
panel that screws up into the frame
from the bottom edge of the panel.
4. Pull the panel straight down until the
top of the panel is visible below the
edge of the countertop.
5. Separate the rear edge of the panel
from the frame, then push the panel
forward off of the front of the frame.
6. Remove the control rod. (SEE CON-
TROL ROD REMOVAL page 4-2)
7. Remove the solid state control panel.
8. Remove two screws (24) that mount
the Power Input Box to the frame.
9. Pull Power Input Box forward. You
may have to remove the locknut from
the conduit fitting on the left side of
the box, as well as any wires that pre-
vent you from moving the box far
enough to access the element mount-
ing nuts.
L U
broaster.com Manual #15460 8/02 Rev 6/15