Broan EVOLUTION 1 QP130BL, Инструкция по эксплуатации

Страница: 4 / 20

MODELS QP130BL • QP130BLC • QP130SS • QP130SSC
QP130WW • QP130WWC • QP136BL • QP136SS • QP136WW
Page 4
9 DUCTED INSTALLATION ONLY:
Remove 3¼” x 10 vertical, 3¼” x 10” horizontal, or 7-inch
round
knockout plate(s)
as appropriate for your ducting
method.
10 DUCTED INSTALLATION ONLY:
Attach 3¼” x 10” Damper/Duct Connector (if using 3¼”
x 10” duct) or
7” Round Duct Plate
(if using 7-inch round
duct) over the knockout opening.
3¼” X 10”
HORIZONTAL
KNOCKOUT
PLATE
3¼” X 10”
VERTICAL
KNOCKOUT
PLATE
7” ROUND
KNOCKOUT
PLATE (also
remove 3¼” x 10”
vertical plate)
3¼” X 10”
DAMPER /
DUCT
CONNECTOR
7” ROUND
DUCT
PLATE
Note:
To accomodate off-center ductwork, the 3¼” x 10” damper/
duct connector can be installed up to ½” on either side
of the hood center and the 7” round duct plate can be
installed up to ½” on either side of the hood center.
Trim the flange on the duct connector or duct plate if it
interferes with the electrical cable clamp.
Install the 3¼” x 10” Damper/Duct Connector with the
Damper Flap Pivot nearest the Top/Back Edge of Hood .
TOP/BACK
EDGE OF
HOOD
7 NON-DUCTED INSTALLATION ONLY:
Remove Center Retaining Screw and loosen Outer
Retaining Screws
holding
Recirculation Slide Plate
in place. Pull out slide plate and replace and tighten
retaining screws to hold slide plate in new (non-ducted)
position.
RECIRCULATION
SLIDE PLATE
CENTER
RETAINING SCREW
PULL OUT
8 NON-DUCTED INSTALLATION ONLY:
Purchase a set of (2) non-ducted filters from your local
distributor or retailer. Attach the non-ducted filters to the
aluminum mesh filters following instructions packed with
the non-ducted filters.
FOR NON-DUCTED INSTALLATIONS - Skip to “INSTALL
THE HOOD”.
OUTER
RETAINING SCREWS
è
INSTALL THE HOOD
WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
WIRING BOX
COVER
11 Remove
Electrical Wiring Box Cover
from inside
of hood and appropriate Electrical Power Cable
Knockout from top or back of hood.
ELECTRICAL POWER
CABLE KNOCKOUT