11
Section B – Cabinet
UPPER
HINGE
PIN
TRIM PIECE
Use a screwdriver to remove the upper hinge pin from
4.
the trim piece and re-install the pin on the opposite
side.
BUSHING
CAP
DOOR
Being careful not to scratch the door, remove the
5.
plastic door bushing and cap from the top and bottom
of the door using a small flat screwdriver. Install the
bushings on the side of the door panel that will be
hinged and install the caps on the opposite side.
Re-install the door (see Remove and Re-install).
6.
Safety Interlock Actuator
REMOvE AND RE-INSTALL
This safety device prevents the compactor from operating
except when the door is closed. NOTE: If the interlock
actuator should break off, the compactor will not function;
replace it promptly.
DOOR
INSULATION
PAD
INNER DOOR
PANEL
14
SCREWS
ACTUATOR
SCREW
Remove the 14 Phillips head screws from the inner
1.
door panel. Remove panel and set aside.
Remove insulation pad from door.
2.
Remove Phillips head screw from inside of door panel
3.
and remove actuator.
Installation is the reverse of removal. NOTE: Fully seat
4.
actuator in the door panel before re-installing screw.
