- 8 -
14. INSTALL THE POWER PACK
Lift the power pack in custom hood until the bottom of the clasping springs
(2 per side) rests on the top of the custom hood base (grey zone in illustration
beside).
From inside the power pack, using provided no. 8-10 x 1/2” screws, mount the
power pack to the custom hood base. To do so, lift one side until its flange rests
on the outer side of the custom hood base and use two (2) screws to secure in
place. Do the same for the other side, then finalise mounting with two (2) other
screws for each side. See figure beside for mounting screws specific locations.
V
ERTICAL
E
XHAUST
I
NSTALLATION ONLY
Make sure the adapter/damper enters the ducting and the damper opens freely.
Wherever it is possible, seal connections with metal foil duct tape.
CAUTION
Take care not to kink ducting or pinch electrical cable when installing the power pack.
HD0
3
62
HH0124
C
LASPING
S
PRINGS
13. CONNECT WIRING
Connect cable using provided wire connectors.
Connect wires as follow: BLACK to BLACK, WHITE to WHITE and GREEN
or BARE wire under ground screw (
A
). DO NOT FORGET TO CONNECT
THE GROUND.
WARNING
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all
applicable codes and standards. Before connecting wires, switch power off at service panel and lock
service disconnecting means to prevent power from being switched on accidentally.
!
HE0059
Position the power pack below the installed custom hood. Insert the house wiring cable through the wire clamp previously
installed in step 10. Tighten the wire clamp to secure the cable.
A
