background image

®

Page 4

MODELS 678 • 678MX • 679 • 680 • 679FL • 680FL

USE AND CARE

USE AND CARE

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND
LOCK OUT SERVICE PANEL BEFORE CLEANING OR SERVIC-
ING THIS UNIT.

BULB REPLACEMENT

Remove lens by gently depressing sides and pull down.
Models 678, 678MX, 679 & 680:
Use 100 Watt maximum incandescent bulb.
Model 679FL:
Use only the following 13 Watt fluorescent lamps: 

Broan 97010729,

Sylvania CF13DD827, Phillips PL-C 13W/27/USA, General Elec-
tric
 F13DBX23T4/SPX27, Osram CF13DD827, NEMA Type
CFQ13W/GX23.
Model 680FL:
Use only the following 22 Watt fluorescent lamps: 

Broan 97015191,

Phillips PL-C 15MM/22W, Panasonic FDL22, NEMA Type
CFQ20W/GX32d.

MOTOR LUBRICATION

The motor is permanently lubricated. Do not oil or disassemble
motor.

CLEANING

TO CLEAN LENS AND GRILLE:

Remove light lens and bulb. Remove nut in center of reflector and
lower assembly.

CAUTION: Grille and reflector are separate units. Unplug light
from WHITE receptacle. Plastic parts can be cleaned with mild,
soapy water (use a mild detergent, such as dishwashing liquid)
and dried with a soft cloth. Do not use abrasive cloth, steel wool
pads, or scouring powders.

TO CLEAN FAN ASSEMBLY:

Unplug fan assembly (BLACK receptacle). To remove motor plate:
Find the single tab on the motor plate (located next to the recep-
tacles). Push up near motor plate tab while pushing out on side of
housing. Or insert a straight-blade screwdriver into slot in housing
(next to tab) and twist screwdriver. Gently vacuum fan, motor and
interior of housing. METAL AND ELECTRICAL PARTS SHOULD
NEVER BE IMMERSED IN WATER.

SERVICE PARTS

WARRANTY

1

2

3

5

4

7

8

13

12

14

20

16

9

10

99042900G

17

11

18

BROAN-NUTONE ONE YEAR LIMITED WARRANTY

Broan-NuTone warrants to the original consumer purchaser of its products that such products will
be free from defects in materials or workmanship for a period of one year from the date of original
purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.
During this one-year period, Broan-NuTone will, at its option, repair or replace, without charge, any
product or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES.
This warranty does not cover (a) normal maintenance and service or (b) any products or parts
which have been subject to misuse, negligence, accident, improper maintenance or repair (other
than by Broan-NuTone), faulty installation or installation contrary to recommended installation
instructions.
The duration of any implied warranty is limited to the one-year period as specified for the express
warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S OP-
TION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS
WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUEN-
TIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE
OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which vary from
state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone number
below, (b) give the model number and part identification and (c) describe the nature of any defect in the
product or part. At the time of requesting warranty service, you must present evidence of the original
purchase date.

KEY

PART NO.

DESCRIPTION

1

97013578

Light Lens

2

97005316

Acorn Nut

3

99770029

Bulb Holder (678, 678MX, 679, 680)

4

97014211

Light Reflector (678, 678MX, 679, 680)

*

97014212

Light Reflector Assembly

(678, 678MX, 679, 680)
(includes Key Nos. 3 & 4)

5

97015202

Lamp Holder Wiring (679FL)

6

98006276

Light Reflector

(679FL)

*

97015167

Light Reflector Assembly

(679FL) (incl. Key Nos. 5 & 6)

*

97015969

Light Reflector Assembly

(680FL)

7

97013974

Grille

8

97014926

Motor Plate

9

99080521

Motor (678)

99080546

Motor (678MX)

99080522

Motor (679, 679FL)

10

99080517

Motor (680, 680FL)

11

99111002

Impeller (678, 678MX)

12

99110446

Impeller (679, 679FL)

13

99020276

Impeller (680, 680FL)

14

99260428

Motor Nut (678, 678MX, 679, 679FL)

(2 req.)

99260425

Motor Nut (680, 680FL) (2 req.)

15

99150582

Grille Screw

*

97015163

Blower Assembly (678)

*

97016207

Blower Assembly (678MX)

*

97015165

Blower Assembly (679, 679FL)

*

97015157

Blower Assembly (680, 680FL)
(Blower Assemblies include

Motor, Impeller, 8, 14 & 15)

16

99270982

Receptacle (Black)

17

99270981

Receptacle (White)

18

98009612

Wire Panel

*

97015171

Wire Panel Assembly

(includes Key Nos. 16,17,18)

19

97014922

Housing

20

97014185

Damper/Duct Connector

21

98008868

Wiring Plate

22

99150575

Screw, #8-18 x .375

23

99150471

Ground Screw

* Not shown assembled.

Order replacement parts by “PART NO.” - not by “KEY NO.”

6

15

19

21

22

23

Broan at

::

bathroomsource

.

com

is a division of

kitchen

::

accessories

U      N      L      I      M      I      T      E      D

::

bathroomsource

.

com

                   

Call 1-800-667-8721 anywhere in the US and Canada -

www.bathroomsource.com

Содержание 678









Отзывы: