e-mail:
voice:
360.854.9559
fax:
866.783.1742
3
WVRC-4 Installation and Operation Manual
INTRODUCTION
INTRODUCTION
Thank you for your purchase of a Broadcast Tools® WVRC-4, Four Channel WEB
and Voice Dial-up Remote Control System (referred to as the WVRC-4 throughout
this manual). We’re confident that this product should give you many years of
dependable service. This manual is intended to give you all the information needed
to install and operate the Broadcast Tools® WVRC-4.
SAFETY INFORMATION
Only qualified technical personnel should install the WVRC-4. Any attempt to install
this device by a person who is not technically qualified could result in a hazardous
condition to the installer or other personnel, and/or damage to the WVRC-4 or other
equipment. Broadcast transmitters can operate at voltages that are potentially lethal.
Please ensure that proper safety precautions have been made before installing this
device. If you are unfamiliar with this type of equipment, please contact a properly
qualified engineer to handle the installation and setup of the WVRC-4.
For additional safety, it is strongly recommended that, in addition to setting the
WVRC-4 in to OP/PGM mode, the remote/local switch on any transmitter or high
voltage equipment also be set to local mode.
While the WVRC-4’s relays are physically capable of handling 250 VAC, this prac-
tice is extremely dangerous and should never be attempted. The pluggable euroblock
screw terminals are not designed to shield humans from potentially dangerous volt-
ages. Contact with high voltages can cause serious injury or death. The maximum
recommended voltage for the WVRC-4 is 30V. Switching of high voltages should
only be done external from the WVRC-4 and in a manner that isolates the voltages
from accidental contact with humans.
WHO TO CONTACT FOR HELP
If you have any questions regarding your product or you need assistance, please con-
tact your distributor from whom you purchased this equipment.
If you would like more information about Broadcast Tools® products, you may
reach us at:
Broadcast Tools, Inc.
131 State Street
Sedro-Woolley, WA 98284-1540 USA
Voice: 360.854.9559
Fax:
866.783.1742
Internet Home Page: www.broadcasttools.com
E-mail:
THANK YOU FOR CHOOSING
BROADCAST TOOLS® BRAND PRODUCTS!
CAUTION!
Broadcast Tools®
Products, as with any
electronic device, can
fail without warning.
Do not use this product
in applications where a
life threatening condi-
tion could result due to
failure. Serious injury
or death can occur if a
command channel is
activated while you are
performing mainte-
nance on your equip-
ment. If you are per-
forming maintenance
on your equipment, you
should press the
“OP/PGM” button on
the front panel of your
WVRC-4 forcing the
unit in to local mode.
The “PGM” LED will
illuminate. Local mode
prevents the unit from
performing relay com-
mands.
NOTE:
This manual should be
read thoroughly before
installation and operation.
