e-mail:
voice:
360.854.9559
fax:
866.783.1742
32
WVRC-4 Installation and Operation Manual
WEB SETUP
The Schedule Detail Dialog is used to set up a single schedule event.
An event specifies an action (raise or lower), a relay or alarm muting/unmuting, and
a time when the action occurs. The scheduler supports both day-of-month and day-
of-week schedules. Wildcards can be specified in any of the date/time fields to cre-
ate a repeating event.
Action
Raise or lower relay, enable alarm, disable alarm.
Relay
User-defined name of the raise or lower relay, alarm
enable/disable (status input, analog input, silence sensor or
power failure).
Month
Select the month when the event should occur, or ALL if the
event should occur during every month.
Day of Month
Select the calendar day when the event should occur, or ALL
if the event should occur every calendar day.
Day of Week
Check the day(s) of the week on which the event should
occur. Check all boxes if the event should occur every day of
the week.
Hour
Select the hour when the event should occur, or ALL if the
event should occur every hour.
Minute
Select the minute when the event should occur, or ALL if the
event should occur every minute.
Second
Select the second when the event should occur, or ALL if the
event should occur every second.
OK
Saves the event and exits.
Cancel
Exits without saving the event.
Examples:
1 - To set up an event that occurs at 12:01AM on January 1, select Month=January,
Day of Month=1, Hour=00, Minute=01, Second=00.
2 - To set up an event that occurs every Tuesday at 9:15AM, select Month=All, Day
of Week=Tuesday, Hour=09, Minute=15, second=00.
A single event can be defined quite flexibly. However, complex schedules might
require multiple events. For example, to schedule an event that occurs at 16:30 on
March 31, June 30, September 30, and December 31 would require four separate
event entries.
