12
Manual Operation
Manual operation requires you to manually control the fan, its speed, and the pump.
Getting started
Begin by pressing the ON/OFF key to turn the Cooler on. For Manual operation the AUTO light must not be illuminated.
• Push the MODE key to cycle through the cooler’s operating modes.
Fan and Pump
This is indicated by the illuminated Fan and Pump lights. The screen will then display a number, which indicates the
cooler fan speed.
• Push the UP and DOWN keys to raise and lower the cooler’s fan speed.
Fan only
This is indicated by the illuminated FAN light. The screen will then display a number, which indicates the cooler’s fan
speed.
• Push the UP and DOWN keys to raise and lower the cooler’s fan speed.
Pump only
This is indicated by the illuminated PUMP light. Only the pump will be running in this mode, and no air will be
circulating.
Using the Timer
This wall control has a timer function that can delay the operation of the ON/OFF key. If the cooler is operating, you
can pre-set the timer for the cooler to turn Off. If the cooler is off you can pre-set the timer for the cooler to turn On.
The timer is set in 1-hour increments, ranging from 1 to 12 hours. When setting the timer to turn the cooler on, the
wall control returns to the settings it had when it last operated. To check or adjust these settings turn the wall control
on, make any adjustments if necessary, then turn the wall control off and set the Timer. When setting the timer to turn
the cooler off, have the cooler running at your desired settings and set the timer.
Setting the Timer
• Press the TIMER key to enter the timer setting mode. The timer light will now be flashing and the screen will
display a number.
• Push the UP and DOWN keys to set the delay in hours. The timer delay can only be adjusted while the timer light
is flashing.
• To cancel the timer push the TIMER key twice or push the ON/OFF key.
• After the timer has been set, leave the controller for five seconds until the timer light stops flashing.
Operating Your Manual Wall Control
The Manual Wall Control requires you to manually control the fan and fan speed, and the Pump and Pre-Wet Function.
• Push the ON/OFF key to turn the controller on.
• Push the Cool switch to the ON position. This will operate the pump.
• Pre-Wet the filter pads by turning the Cool switch on 5–10 minutes before
switching the fan ON. This will provide maximum cooling immediately when the fan is
switched ON.
• Turn the Fan switch ON.
• Rotate the Fan Speed dial to the airflow level you desire.
Note:
The fan light will flash during the Pre-Wet period.
Note:
On days of high humidity the fan may be operated without the pump. For ventilation only, operate the
cooler in this mode.
Note:
On days of high humidity the fan may be operated without the pump. For ventilation only, turn the Cool
switch OFF which turns the pump OFF.
CAAB022832O Cool Owners ISSUE D_021073O 24/08/15 10:21 AM Page 14
