Instructions for Installation & Use - Series No. 6100/A/2013
Instructions for Installation & Use - Series No. 6100/A/2013
40
41
INSTALLATION OF CAR'S UPPER
ANCHORAGE POINT
INSTALLATION OF CAR'S UPPER
ANCHORAGE POINT
Top tether extension Strap distance to be measured.
Length 300mm (Use Britax Safe-n-Sound part 0035).
Length 600mm (Use Britax Safe-n-Sound part 0036).
Available from all major child restraint retailers.
Distance to measure to the upper
anchorage point
The shaded areas of this diagram illustrate the possible locations of the upper anchorage point. Within
each shaded area is an upper anchorage point showing the correct way to install the fitting. Ensure the
upper anchorage point is aligned as illustrated unless stated otherwise in the vehicle owner’s handbook.
Adjustable top tether
strap.
Front of Vehicle
45
°
IF THE CAR IS FITTED WITH CHILD RESTRAINT
UPPER ANCHORAGE POINT
Locate the upper anchorage point behind the rear seating position.
(Consult the car owners handbook for the location of the upper
anchorage point). The upper anchorage point should be directly
behind and central to the restraint. Remove thread plug from the
parcel shelf/floor/roof, etc. and install attachment bolt and fitting
as shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ATTACHMENT BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 Nm(14.75 ft.lb.)
Note: Minimum of five full turns of attachment bolt is required before
tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT UPPER ANCHORAGE POINTS
For Sedans only
- Drill 9mm diameter hole in the parcel shelf
on the centre line of the seating position as shown in Fig 3.
Before drilling the hole, check the underside for accessibility.
Install the attachment bolt as shown in Fig 2. It is recommended
that this installation be carried out by a child restraint fitting
station or licenced motor mechanic.
For vehicles other than Sedans
- In Australia, consult your
nearest child restraint fitting station or traffic authority for vehicle
inspection to find the preferred position for the placement of
the upper anchorage point, and for the correct attachment bolt
length and use of spacers. In New Zealand, consult the agent
for the vehicle. Note to Queensland purchasers: The installation
of anchorage points must be approved by authorised officers
appointed by Queensland Transport. Authorised officers can be
sourced from all Queensland Transport Customer Service and
Queensland Ambulance Service Centres.
Front of Vehicle
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards).
Lock washer
Secure nut
UPPER ANCHORAGE FIT-
TINGS FOR SEDANS ONLY
Vehicle trim
UPPER ANCHORAGE FITTING
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Vehicle trim
Fig.1.
Fig.2.
