Instructions for Installation & Use
- Series No. JS8A/2010
HOW TO INSTALL WITH A CHILD HARNESS
44
CHOOSING METHOD OF INSTALLATION
The child harness can be installed using either of the following methods.
METHOD 1 :
Using a lap sash seatbelt in conjunction with Gated 3-bar
Slide (provided with the child harness) to convert to lap belt plus upper
anchorage strap.
METHOD 2 :
Using lap seatbelt plus upper anchorage strap.
Before installing the child harness determine which method of installation
is required and follow instructions carefully.
When using the child harness, ensure the 'built-in' shoulder harness is and
stored. Set up the SLIDEGUARD™ Converter. Refer to pages 34-35.
SLIDEGUARD™
converter not yet
engaged
THIS BOOSTER SEAT MAY ONLY BE SUITABLE FOR USE WITH A CHILD HARNESS IN THE UPRIGHT
POSITION. IN THE RECLINE POSITION, THE VEHICLE'S SEATBELT MAY NOT BE LONG ENOUGH.
Click
NOTE:
Some vehicle seatbelts are too short and you may experience some difficulty fitting the
converted lap-sash around your child. If so, adjust the gated slide nearer to your child, ideally
under the armrest and lap belt recess area (ensure the slide does not touch your child). This should
provide more belt length to fit your child, but if the belt still will not fit, try another location in the
vehicle, e.g. side seat. If the vehicle belts are still too short, then contact the vehicle manufacturer
for advice on longer seatbelts.
BOOSTER MODE
WITH CHILD H
ARNE
SS
