Instructions for Installation & Use
- Series No. JS8A/2010
14
HOW TO SETUP
SETTING UP THE HARNESS
A.
Sit the restraint on a flat ground and supported from behind so that it will not tip over.
B.
Get the child to sit comfortably in position.
C.
Determine the desired shoulder strap position.
D.
Remove the child and adjust the shoulder straps using the following methods.
ADJUSTING THE BUCKLE POSITION
The Child restraint is supplied with the crotch straps
set at the correct position for use with the built-in
harness.
The buckle needs to be positioned as shown. If the
buckle is too low it will be uncomfortable and needs to
be lengthened. See next page.
You must adjust the crotch strap to the correct length for your child before installing the restraint
as it cannot be adjusted in the car. The crotch strap should only be extended if the harness
tongues are located low against your child's legs, thus creating discomfort.
Always return the crotch strap to its shorter length when using the seat with a smaller child.
The buckle should always be positioned low down on your child's abdomen.
DO NOT attempt to remove the crotch strap from the adjuster. Adjustment is made by feeding the
crotch strap through the adjuster as shown on the next page and does not need to be removed
from the seat.
IMPORTANT :
Buckle Position
OK
Center of button on
buckle, level with top
of legs (with all slack
removed from crotch
strap.)
FORWARD FACING
WITH BUILT-IN HARNESS
